The Enable-IT™ 865 - Power over Ethernet(PoE) and 100Mbps Full Duplex Ethernet Extender Kit
The
Enable-IT™ 865 Power Over Ethernet and LAN Extender is the world’s only available solution to deliver Voice, Data and PoE in a combined package
that exceeds the IEEE distance limitations for all Ethernet equipment. The 865 kit enables the simple installation of a PoE device up to 1,500ft (457m) from your
LAN and Power Source. – This is ideal for installing PoE IP Security cameras or PoE WiFi Access Points.
These extenders drive
the reach of Ethernet to almost 5 (five) times the typical IEEE Ethernet specification distance of 328ft or 100m
including PoE Power to drive up to a 24v PoE device. The 865 kit can even be used on live voice wiring transparently; try that with your
expensive LRE. No other Ethernet Extender manufacturer supports
voice over the same pair of wire with data. Only Enable-IT
extenders can.
To increase the durability and extended use of the product providing
maximum future technology protection, 865 Extended Ethernet Units have
been designed to meet the challenge of modern switched LANs and allows
you to add features and capacity as your network expands. The 865 units
have been tested to provide full duplex transport up to 100MB/s over
CAT3 cabling or better.
Product Features
Product Specifications
5v country specific adapter for CO (local end) included.
Enable-IT 350 48v PoE Injector for CPE & PoE device
100Mbps full-duplex, Data & Voice transmission
Ethernet: RJ-45 Standard
Voice/Data Line: RJ-11 - Dual line
Height 1.5" (38mm) Length 5.75" (146mm) Width 3.75" (95mm)
Operational Temperature : -4°-160°F (-20°- 70°C)
Humidity: 5%-95%, non-condensing
Square wall mountable casing with dual RJ-45 / single RJ-11 port
Product Highlights
For detailed installation and printable product information, please see the following
documents.
